No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionServer Pro XH628 V5 Server Node V100R005 Maintenance and Service Guide 03

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing a Front SAS/SATA Drive

Installing a Front SAS/SATA Drive

  • The SATA or SAS drives support hot swap. After a faulty drive is disconnected from its backplane, wait 30 seconds before removing it. The alarm will not be cleared immediately after a new drive is installed. It will be cleared after the RAID array rebuild is complete. Do not frequently hot-swap a drive to prevent new alarms.
  • To prevent damage caused by insufficient heat dissipation and high temperature, install components or filler panels.

Procedure

  1. Take the spare part out of its ESD bag.
  2. Determine the slot and position of the drive.

    For details, see Drive Configurations and Drive Numbering.

  3. Remove the drive filler.

    NOTE:

    Perform this operation only when a drive filler is installed.

    Squeeze the latches of the drive filler and pull it out of the slot. See (1) and (2) in Figure 3-24.

    Figure 3-24 Removing a drive filler

  4. Install a drive.

    1. Fully open the ejector lever and push the drive into the slot as far as it will go. See (1) in Figure 3-25.
    2. Ensure that the ejector lever is fastened to the chassis beam, and then close it to completely insert the drive into the slot. See (2) in Figure 3-25.
    Figure 3-25 Installing a drive

  5. Check the running status of the drive by observing its indicators.

    For details, see SAS/SATA Drive Indicators.

  6. Restore the drive data.

    NOTE:

    Perform this operation only when you replace a drive.

    For details, see Troubleshooting > Hard Drive Fault in Huawei V5 Server RAID Controller Card User Guide.

Translation
Download
Updated: 2019-08-12

Document ID: EDOC1100036739

Views: 13238

Downloads: 20

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next