No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionServer Pro XH628 V5 Server Node V100R005 Maintenance and Service Guide 03

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Power-On Procedure

Power-On Procedure

  • Before powering on a server node, ensure that the PSUs are switched off, all cables are connected correctly, and the power supply voltage meets service requirements.
  • During the power-on process, do not remove and insert drives or disconnect and connect network cables or Console port cables.
  • If a server node is powered off, wait for at least one minute before powering it on again.

The server node can be powered on in any of the following ways:

  • If the server node is installed but the chassis is not yet powered on, power on the chassis.

    The server node will be powered on along with the chassis.

  • If the chassis is powered on but the server node is not installed, install the server node.

    The server node will be automatically powered on after it is installed.

  • If the chassis is powered on but the server node is not running properly, hold the power button the front panel for six seconds to power off the service node forcibly, and then press the power button to power it on.
  • If the chassis is powered on and the server node is in standby state (the power indicator is steady yellow), you can use any of the following methods to power on the server node:
    • Use the iBMC WebUI.
      1. Log in to the iBMC WebUI.

        For details, see Logging In to the iBMC WebUI.

      2. Choose Power > Power Control.

        The Power Control page is displayed.

      3. Click Power On.

        A confirmation message is displayed.

      4. Click Yes.
    • Use the iBMC CLI.
      1. Log in to the iBMC CLI.

        For details, see Logging In to the CLI.

      2. Run the following command:

        ipmcset -d powerstate -v 1

      3. Type y or Y and press Enter.
    • Use the Remote Virtual Console.
      1. Log in to the Remote Virtual Console.

        For details, see Logging In to the Desktop of a Server.

      2. On the KVM screen, click or on the toolbar.
      3. Select Power On.

        A dialog box is displayed.

      4. Click Yes.
Translation
Download
Updated: 2019-08-12

Document ID: EDOC1100036739

Views: 13617

Downloads: 20

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next