No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionServer Pro XH628 V5 Server Node V100R005 Maintenance and Service Guide 03

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Installing a Drive in the Drive Drawer

Installing a Drive in the Drive Drawer

The drive drawer can hold twelve 2.5- or 3.5-inch SAS/SATA drives. The methods for installing the drives are the same.

  • The SATA or SAS drives support hot swap. After a faulty drive is disconnected from its backplane, wait 30 seconds before removing it. The alarm will not be cleared immediately after a new drive is installed. It will be cleared after the RAID array rebuild is complete. Do not frequently hot-swap a drive to prevent new alarms.
  • To prevent damage caused by insufficient heat dissipation and high temperature, install components or filler panels.

Procedure

  1. Take the spare part out of its ESD bag.
  2. Determine the position and slot of the drive.

    For details, see Drive Configurations and Drive Numbering.

    Figure 4-4 Drive positions and slot numbers

  3. Remove the drive filler.

    NOTE:

    Perform this operation only when a drive filler is installed.

  4. Install the drive in the drawer.

    1. Open the drive drawer.

      Do not exert excessive force on the drive drawer when removing or installing it. Otherwise, the drives may be damaged.

    2. Holding the drive handle, install the drive into the slot until the handle is flush with the upper edge of the drive drawer. See (1) in Figure 4-5.
    3. Holding the handle of the drive drawer, slowly push the drive drawer into the server node until it clicks into place. See (2) in Figure 4-5.
      Figure 4-5 Installing a drive drawer

  5. Check the running status of the drive by observing its indicators.

    For details, see Drive Drawer Indicators.

  6. Restore the drive data.

    NOTE:

    Perform this operation only after you replace a drive.

    For details, see Troubleshooting > Hard Drive Fault in Huawei V5 Server RAID Controller Card User Guide.

Translation
Download
Updated: 2019-08-12

Document ID: EDOC1100036739

Views: 13650

Downloads: 20

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next