No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

FusionServer Pro XH628 V5 Server Node V100R005 Maintenance and Service Guide 03

Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Removing a Front SAS/SATA Drive

Removing a Front SAS/SATA Drive

NOTE:
  • The SATA or SAS drives support hot swap.
    • If the drive to be removed has no operating system installed, you can remove it without powering off the server node.
    • If the drive to be removed has the operating system installed and belongs to a RAID array with redundancy, you can remove it without powering off the server node.
    • If the drive to be removed has the operating system installed but it is not in a RAID array or it is in a RAID array without redundancy (for example, RAID 0), power off the server node before removing it.
  • The SAS/SATA drives support RAID configuration.
    • If the drive to be removed is not in a RAID array or is in a RAID array without redundancy (for example, RAID 0), back up the data on the drive before removing it.
    • If the drive to be removed is in a RAID array with redundancy, you do not need to back up data before removing it.

Procedure

  1. Determine the slot and position of the drive.

    For details, see Drive Configurations and Drive Numbering.

  2. Check the running status of the drive by observing its indicators.

    For details, see SAS/SATA Drive Indicators.

  3. Determine whether the drive needs to be removed.

    • If yes, go to 4.
    • If no, rectify the drive fault.

  4. Remove the drive.

    1. Press the ejector release button on the drive panel to release the ejector lever. See (1) in Figure 3-23.
    2. Open the drive ejector lever completely. See (2) in Figure 3-23.
    3. Holding the ejector lever of the drive, pull out the drive for about 3 cm (1.18 in.). Wait for at least 30 seconds and remove the drive from the server. See (3) in Figure 3-23.

      Do not insert or remove drives frequently. If a drive is frequently removed and installed in an interval shorter than 30 seconds, there are risks that the drive cannot be identified.

    Figure 3-23 Removing a drive

  5. Place the removed component in an ESD bag.
  6. Install a drive filler.

    NOTE:

    Perform this operation only when a drive is not installed immediately.

Translation
Download
Updated: 2019-08-12

Document ID: EDOC1100036739

Views: 16267

Downloads: 20

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next