- About This Document
- Basic Configuration for Interfaces
- Ethernet Interface Configuration
- Overview of Ethernet Interfaces
- Licensing Requirements and Limitations for Ethernet Interfaces
- Default Settings for Ethernet Interfaces
- Configuring a Port Group
- Configuring Port Isolation
- Configuring Port Protection
- Configuring the Rate and Duplex Mode
- Configuring Common Attributes of Optical and Electrical Interfaces
- Configuring Flow Control
- Configuring the Delay in Reporting Physical Status Changes
- Configuring Link Flapping Protection
- Configuring an Interface to Transit to the Error-Down State When the Number of Received Error Packets Exceeds the Threshold
- Configuring the Device to Count the IFG and Preamble Traffic Statistics
- Setting the Jumbo Frame Length Allowed on an Interface
- Configuring the Log and Alarm Threshold for Inbound and Outbound Bandwidth Usage
- (Optional) Configuring the Trap Threshold for a Sudden Traffic Volume Change on Interfaces
- (Optional) Disabling Detection of a Sudden Broadcast Traffic Volume Change in the Inbound Direction of Interfaces
- Enabling the Log Function for Inbound and Outbound Packet Loss Caused by Congestion
- Configuring Optical Interface Attributes
- Configuring Electrical Interface Attributes
- Maintaining Ethernet Interfaces
- Configuration Examples for Ethernet Interfaces
- Troubleshooting Ethernet Interfaces
- FAQ About Ethernet Interfaces
- How Can Two Interfaces at Both Ends of a Link Determine the Rate and Duplex Mode Through Auto-Negotiation?
- How Can Packet Loss Be Avoided When Two Interfaces at Both Ends of a Link Work in Auto-Negotiation Mode and Use the Half-Duplex Mode?
- What Interface Attributes Are Affected After the Interface Auto-Negotiation Mode Is Changed?
- How Do I Use Port Isolation to Prevent Users in the Same VLAN from Communicating with Each Other?
- How Do I Check the Interfaces with Port Isolation Enabled?
- How Do I Configure Multiple Physical Interfaces in a Batch?
- How Do I Check Member Interfaces in a Port Group?
- Why Is a Non-Connected Interface Up?
- Do Traffic Statistics on an Interface Contain the IFG and Preamble?
- Can an IP Address Be Directly Assigned to a Physical Interface?
- Logical Interface Configuration