No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R012C00 Configuration Guide - Interface Management

This document describes the interface management configuration, including basic interface configuration, Ethernet interface configuration, and logical interface configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Can Packet Loss Be Avoided When Two Interfaces at Both Ends of a Link Work in Auto-Negotiation Mode and Use the Half-Duplex Mode?

How Can Packet Loss Be Avoided When Two Interfaces at Both Ends of a Link Work in Auto-Negotiation Mode and Use the Half-Duplex Mode?

You can configure the local and remote devices to work in non-auto-negotiation mode, and set their duplex mode to full-duplex to avoid packet loss.

The configuration is as follows:
<HUAWEI> system-view
[HUAWEI] interface gigabitethernet 0/0/1
[HUAWEI-GigabitEthernet0/0/1] undo negotiation auto
[HUAWEI-GigabitEthernet0/0/1] duplex full
Translation
Download
Updated: 2018-09-01

Document ID: EDOC1100037947

Views: 4585

Downloads: 4

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next