No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R012C00 Configuration Guide - Interface Management

This document describes the interface management configuration, including basic interface configuration, Ethernet interface configuration, and logical interface configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Do I Configure Multiple Physical Interfaces in a Batch?

How Do I Configure Multiple Physical Interfaces in a Batch?

You can add multiple Ethernet interfaces to the same port group. After you run a configuration command once in the port group view, the configuration takes effect on all the Ethernet interfaces in the port group, reducing the configuration workload.

# Add GE0/0/1 to GE0/0/20 to port group portgroup1.
<HUAWEI> system-view
[HUAWEI] port-group portgroup1
[HUAWEI-port-group-portgroup1] group-member gigabitethernet 0/0/1 to gigabitethernet 0/0/20
Updated: 2018-09-01

Document ID: EDOC1100037947

Views: 5051

Downloads: 4

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next