No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R012C00 Configuration Guide - Interface Management

This document describes the interface management configuration, including basic interface configuration, Ethernet interface configuration, and logical interface configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How Do I Check Member Interfaces in a Port Group?

How Do I Check Member Interfaces in a Port Group?

You can run the display port-group [ all | port-group-name ] command to check member interfaces in a permanent port group.

The port group function allows you to configure interfaces in a batch. However, the device does not support query or saving of the port group configuration. You can run the display this command in the interface view of a member interface to check the configuration that takes effect on the interface.

# Check member interfaces in all permanent port groups.

<HUAWEI> display port-group all
Portgroup: 1
Portgroup: 2
Updated: 2018-09-01

Document ID: EDOC1100037947

Views: 4571

Downloads: 4

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next