No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R012C00 Configuration Guide - Interface Management

This document describes the interface management configuration, including basic interface configuration, Ethernet interface configuration, and logical interface configuration.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a VLANIF Interface

Configuring a VLANIF Interface

Context

A VLANIF interface is a Layer 3 logical interface. After an IP address is assigned, the VLANIF interface enables VLANs to communicate and can have Layer 3 services deployed.
NOTE:
A VLANIF interface goes Up only after the following conditions are met:
  • The corresponding VLAN must have been created.
  • A physical interface or Eth-Trunk in Up state has been added to the corresponding VLAN.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface vlanif vlan-id

    A VLANIF interface is created and the VLANIF interface view is displayed.

  3. Run ip address ip-address { mask | mask-length } [ sub ]

    An IP address is assigned to the VLANIF interface.

  4. (Optional) Run damping time delay-time

    The delay after which the VLANIF interface goes Down is set.

    By default, the delay is 0 seconds, that is, a VLANIF interface goes Down immediately after the corresponding VLAN goes Down.

    Setting a delay after which a VLANIF interface goes Down prevents network flapping caused by status change of the VLANIF interface. This function is also called VLAN damping.

    Enable the VLAN damping function on the VLANIF interface. After the last member interface in Up state in the corresponding VLAN goes Down, the VLAN damping-enabled device reports the VLAN Down event to the VLANIF interface after the configured delay. If a member interface in the VLAN goes Up during the delay, the VLANIF interface remains in Up state.

  5. (Optional) Run mtu mtu

    The MTU of the VLANIF interface is set.

    By default, the MTU of a VLANIF interface is 1500 bytes.

Verifying the Configuration

  • Run the display interface vlanif vlan-id command to view the status of a VLANIF interface.
Translation
Download
Updated: 2018-09-01

Document ID: EDOC1100037947

Views: 5019

Downloads: 4

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next