No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R012C00 Configuration Guide - IP Multicast

This document describes the configurations of IP multicast, including IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, controllable multicast, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Overview of IGMP Snooping

Overview of IGMP Snooping

Definition

Internet Group Management Protocol (IGMP) snooping is a Layer 2 IPv4 multicast protocol. It listens to multicast protocol packets exchanged between the upstream Layer 3 multicast device and downstream hosts to maintain outbound interfaces of multicast packets. Based on the outbound interface information, IGMP snooping manages and controls the multicast forwarding at the data link layer.

Purpose

In most cases, especially in a LAN, multicast packets must pass through Layer 2 devices. In Figure 1-1, multicast packets must pass through a Layer 2 switch between multicast users and the router (Layer 3 multicast device).

Figure 1-1  IGMP snooping network

After receiving multicast packets from the router, the switch forwards the multicast packets to the receivers. The destination address of multicast packets is a multicast group address. The switch cannot learn multicast MAC addresses, so it broadcasts multicast packets in the broadcast domain. All hosts in the broadcast domain will receive the multicast packets, regardless of whether they are members of the multicast group. This wastes network bandwidth and threatens network security.

IGMP snooping solves this problem. With IGMP snooping enabled, a Layer 2 multicast device can listen to and analyze IGMP messages between multicast users and the upstream router. The Layer 2 multicast device sets up Layer 2 multicast forwarding entries to control multicast data forwarding. In this way, multicast data is not broadcast on the Layer 2 network.

Translation
Download
Updated: 2018-09-01

Document ID: EDOC1100037948

Views: 12448

Downloads: 5

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next