No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R012C00 Configuration Guide - IP Multicast

This document describes the configurations of IP multicast, including IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, controllable multicast, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling IGMP Snooping

Enabling IGMP Snooping

Context

Other IGMP snooping functions can be configured only after IGMP snooping is enabled globally. Other IGMP snooping functions take effect in a VLAN only after IGMP snooping is enabled in the VLAN.

By default, IGMP snooping is disabled globally on the switch.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run igmp-snooping enable

    IGMP snooping is enabled globally.

  3. Run vlan vlan-id

    The VLAN view is displayed.

  4. (Optional) Run l2-multicast forwarding-mode { ip | mac }

    The multicast forwarding mode in the VLAN is set to IP address-based or MAC address-based forwarding.

    By default, multicast flows are forwarded based on IP addresses.

    NOTE:
    • Configure the forwarding mode of multicast flows in the VLAN before IGMP snooping is enabled in the VLAN. Enable IGMP snooping in the VLAN for the configuration to take effect.

    • After the multicast data forwarding mode is set to MAC address-based forwarding in a VLAN using this command, the VLAN cannot be configured as a multicast VLAN.

    • If the device forwards multicast data packets based on MAC addresses, do not use a group address on the network if the group address maps to the same multicast MAC address as a multicast IP address reserved for a protocol. Otherwise, the protocol that uses this multicast IP address cannot run normally. For example, OSPF uses 224.0.0.5 to send protocol packets. This multicast IP address maps to multicast MAC address 01-00-5E-00-00-05. If multicast data packets are forwarded based on MAC addresses and use multicast IP address 225.0.0.5 (also mapping to 01-00-5E-00-00-05), the OSPF protocol cannot run normally.

  5. (Optional) Run l2-multicast router-port-discard

    The switch is disabled from forwarding multicast data to router ports in a VLAN.

    NOTE:

    Before disabling the switch from forwarding multicast data to router ports in a VLAN, disable IGMP snooping in the VLAN. After setting the forwarding mode, enable IGMP snooping in the VLAN for the configuration to take effect.

  6. Run igmp-snooping enable

    IGMP snooping is enabled in the VLAN.

    Run the igmp-snooping enable [ vlan { vlan-id1 [ to vlan-id2 ] } &<1-10> ] command in the system view to enable IGMP snooping in multiple VLANs.

    IGMP snooping cannot be used with N:1 (N > 1) VLAN mapping.

Translation
Download
Updated: 2018-09-01

Document ID: EDOC1100037948

Views: 12206

Downloads: 5

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next