No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R012C00 Configuration Guide - IP Multicast

This document describes the configurations of IP multicast, including IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, controllable multicast, multicast network management.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Suppressing Report and Leave Messages

(Optional) Suppressing Report and Leave Messages

Context

IGMP periodically sends Query and Response messages to maintain group memberships. When multiple members join the same multicast group, they send a large number of identical Report messages to the IGMP router. When IGMPv2 or IGMPv3 hosts leave a multicast group, they send a large number of identical Leave messages. To conserve bandwidth, configure suppression for Report and Leave messages on the Layer 2 device.

After message suppression is configured, the switch forwards a Report message only when the first member joins a group or when it receives an IGMP Query message. The switch sends a Leave message only when the last member leaves the group.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run vlan vlan-id

    The VLAN view is displayed.

  3. Run igmp-snooping report-suppress

    Report and Leave message suppression is configured.

    NOTE:

    When configuring message suppression, pay attention to the following points:

    • IGMP snooping proxy and message suppression cannot be configured in the same VLAN.
    • If multicast VLAN replication is configured on the switch, the IGMP message suppression function cannot be enabled in user VLANs.
    • The switch can suppress duplicate IGMPv1 or IGMPv2 Report messages even when IGMP message suppression is disabled. The default suppression time is 10 seconds. To change the suppression time, run the igmp-snooping suppress-time suppress-time command. If suppress-time is set to 0, all the membership report packets are forwarded immediately.

Translation
Download
Updated: 2018-09-01

Document ID: EDOC1100037948

Views: 10068

Downloads: 4

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next