No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R012C00 Configuration Guide - IP Multicast

This document describes the configurations of IP multicast, including IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, controllable multicast, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Host-based Fast Leave

Configuring Host-based Fast Leave


The host-based fast leave function enables a switch to delete a host from the host list of a group immediately after receiving an IGMP Leave message from the host. If the deleted host is the last receiver host connected to the group member port, the switch deletes the forwarding entry of the group from the port, without waiting the aging timer of the port to expire. This conserves bandwidth and system resources.


Host-based fast leave takes effect in a VLAN only when the switch can process IGMPv2 messages in the VLAN.


  1. Run system-view

    The system view is displayed.

  2. Run vlan vlan-id

    The VLAN view is displayed.

  3. Run igmp-snooping host-based prompt-leave

    Host-based fast leave is enabled.

    By default, host-based fast leave is disabled.

Updated: 2018-09-01

Document ID: EDOC1100037948

Views: 12998

Downloads: 5

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next