No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R012C00 Configuration Guide - IP Multicast

This document describes the configurations of IP multicast, including IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, controllable multicast, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling Fast Multicast Forwarding Path Switching upon STP Topology Changes

Enabling Fast Multicast Forwarding Path Switching upon STP Topology Changes

Context

When a Layer 2 network topology changes, multicast forwarding paths may change. Sending IGMP Query Messages upon Topology Changes enables multicast data flows to be switched to new forwarding paths within a relatively short time. However, the downstream device may not receive Query messages immediately after convergence of the Layer 2 network, because Query messaged are sent after a certain interval (60 seconds by default). As a result, multicast traffic cannot be rapidly switched to the new forwarding paths.

If the Layer 2 network is running the Spanning Tree Protocol (STP), you can enable fast multicast forwarding path switching upon STP topology changes. When the STP topology changes, this function quickly changes the ports in Forwarding state into router ports to direct multicast data flows to new forwarding paths.

NOTE:
  • This function takes effect only when STP is used as the loop prevention protocol on a Layer 2 network and the STP operation mode is Multiple Spanning Tree Protocol (MSTP), Rapid Spanning Tree Protocol (RSTP), or STP.
  • With this function configured, the switch sets all ports in Forwarding state as router ports when the STP topology changes. Multicast data flows are forwarded to all the router ports before the router ports are aged out. This will cause increase in multicast traffic.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run igmp-snooping fast-switch enable

    Fast multicast forwarding path switching upon STP topology changes is enabled.

    By default, this function is disabled.

Translation
Download
Updated: 2018-09-01

Document ID: EDOC1100037948

Views: 12267

Downloads: 5

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next