No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R012C00 Configuration Guide - IP Multicast

This document describes the configurations of IP multicast, including IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, controllable multicast, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Clearing IGMP Snooping Entries

Clearing IGMP Snooping Entries

Context

Static and dynamic IGMP snooping entries are cleared in different ways.

NOTICE:

Static entries cannot be restored after being cleared. They will be created when you configure static member ports.

When dynamic entries in a forwarding table are cleared, hosts in the VLAN temporarily do not receive the multicast packets. These hosts can receive multicast packets again only after they send IGMP Report messages and the switch creates forwarding entries.

Procedure

  • Run the undo l2-multicast static-group [ source-address source-ip-address ] group-address group-ip-address vlan { all | { vlan-id1 [ to vlan-id2 ] } &<1-10> } command in the interface view to remove the interface from a multicast group.

    You can run the following commands to batch remove multicast group addresses from an interface.

    • undo l2-multicast static-group [ source-address source-ip-address ] group-address group-ip-address1 to group-ip-address2 vlan vlan-id
    • undo l2-multicast static-group [ source-address source-ip-address ] group-address all vlan { all | { vlan-id1 [ to vlan-id2 ] } &<1-10> }

  • Run the reset igmp-snooping group { all | vlan { all | vlan-id [ [ source-address source-address ] group-address group-address ] } } command in the user view to remove dynamic entries in a forwarding table.
Translation
Download
Updated: 2018-09-01

Document ID: EDOC1100037948

Views: 12249

Downloads: 5

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next