No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R012C00 Configuration Guide - IP Multicast

This document describes the configurations of IP multicast, including IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, controllable multicast, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Licensing Requirements and Limitations for MLD Snooping

Licensing Requirements and Limitations for MLD Snooping

Involved Network Elements

An IPv6 multicast network consists of the following network elements:
  • Multicast source

    A device that sends multicast data to receiver hosts. For example, a video server is a multicast source.

  • IPv6 Protocol Independent Multicast (PIM) device

    A device that uses the IPv6 PIM protocol to generate and maintain multicast routing entries and forwards multicast data based on multicast routing entries. On an IPv6 multicast network, all Layer 3 devices must run IPv6 PIM; otherwise, multicast forwarding paths cannot be established.

  • MLD querier

    A device that exchanges MLD messages with receiver hosts to create and maintain group memberships. On a multicast network, Layer 3 devices connected to network segments of receivers must run the MLD protocol or be configured with static MLD groups. Otherwise, upstream PIM devices cannot know the multicast groups that users want to join, and therefore cannot establish multicast forwarding paths.

  • MLD snooping device

    A device that listens to MLD messages exchanged between upstream Layer 3 multicast devices and receiver hosts to create and maintain Layer 2 multicast forwarding entries, which are used for accurate multicast data forwarding on a Layer 2 network. To prevent broadcasting of multicast packets on a Layer 2 network and conserve network bandwidth, it is recommended that you configure MLD snooping on Layer 2 devices.

  • Receiver

    A multicast user that receives multicast data. A receiver can be a PC, a set top box, or any device with multicast client installed.

The "MLD Snooping Configuration" chapter describes how to configure MLD snooping on a Layer 2 device.

Licensing Requirements

MLD snooping is a basic feature of a switch and is not under license control.

Version Requirements

Table 2-5  Products and versions supporting MLD snooping
Product Model Software Version
S600-E

V200R010C00, V200R011C00, V200R011C10, V200R012C00

NOTE:
For details about software mappings, visit Hardware Query Tool and search for the desired product model.

Feature Limitations

  • All the MLD snooping configurations on interfaces mentioned in this chapter are performed on Layer 2 physical interfaces, including Eth-Trunk interfaces.
Translation
Download
Updated: 2018-09-01

Document ID: EDOC1100037948

Views: 12358

Downloads: 5

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next