No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R012C00 Configuration Guide - IP Multicast

This document describes the configurations of IP multicast, including IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, controllable multicast, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling MLD Snooping

Enabling MLD Snooping

Context

Global MLD snooping must be enabled before other MLD snooping configurations can be performed. Enabling MLD snooping in a VLAN is required for other MLD snooping configurations to take effect in the VLAN. If MLD snooping is disabled in a VLAN, other MLD snooping configurations can be performed but do not take effect until MLD snooping is enabled in the VLAN.

By default, MLD snooping is disabled globally.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run mld-snooping enable

    MLD snooping is enabled globally.

  3. Run vlan vlan-id

    The VLAN view is displayed.

  4. (Optional) Run l2-multicast forwarding-mode { ip | mac }

    The multicast forwarding mode in the VLAN is set to IP address-based or MAC address-based forwarding.

    By default, the IP address-based forwarding mode is used.

    NOTE:
    • Set the multicast forwarding mode before enabling MLD snooping in the VLAN. The specified multicast forwarding mode takes effect only after MLD snooping is enabled.

    • A VLAN cannot be configured as a multicast VLAN after MAC address-based forwarding is configured in the VLAN using this command.

    • If the switch forwards multicast data packets based on MAC addresses, do not use a group address that maps to the same multicast MAC address as a multicast IP address reserved for a protocol. Otherwise, the protocol that uses the multicast IP address cannot run normally. For example, OSPF uses FF02::5 to send protocol packets. This multicast IP address maps to multicast MAC address 33-33-00-00-00-05. If multicast data packets are forwarded based on MAC addresses and use multicast IP address FF13::5 (also mapping to 33-33-00-00-00-05), the OSPF protocol cannot run normally.

  5. (Optional) Run l2-multicast router-port-discard

    The switch is disabled from forwarding multicast data to router ports in a VLAN.

    NOTE:

    Before disabling the switch from forwarding multicast data to router ports in a VLAN, disable MLD snooping in the VLAN. After setting the forwarding mode, enable MLD snooping in the VLAN for the configuration to take effect.

  6. Run mld-snooping enable

    MLD snooping is enabled in the VLAN.

    To enable MLD snooping in multiple VLANs, run mld-snooping enable [ vlan { vlan-id1 [ to vlan-id2 ] } &<1-10> ] command in the system view.

    IGMP snooping cannot be used with N:1 (N > 1) VLAN mapping.

Translation
Download
Updated: 2018-09-01

Document ID: EDOC1100037948

Views: 13223

Downloads: 5

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next