No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S600-E V200R012C00 Configuration Guide - IP Multicast

This document describes the configurations of IP multicast, including IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, controllable multicast, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Configuring a Static Router Port

(Optional) Configuring a Static Router Port

Context

A router port is the port that a Layer 2 device uses to receive multicast protocol packets from the upstream Layer 3 multicast router or Layer 3 switch. The router port forwards packets received from the upstream device to group member ports. After MLD snooping is enabled in a VLAN, all interfaces in the VLAN learn multicast protocols packets by default. When an interface receives an MLD Query or PIM hello message, it becomes a dynamic router port. A dynamic router port has an aging timer.

To enable hosts to always receive multicast packets from an interface, configure the interface as a static router port. Static router ports will never age. You can use the undo command to delete static router ports.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The interface view is displayed.

  3. (Optional) Run undo mld-snooping router-learning vlan { { vlan-id1 [ to vlan-id2 ] } &<1-10> | all }

    Dynamic learning of router ports is disabled.

    By default, dynamic learning of router ports is enabled.

  4. Run mld-snooping static-router-port vlan vlan-id

    An interface is configured as a static router port.

Translation
Download
Updated: 2018-09-01

Document ID: EDOC1100037948

Views: 13346

Downloads: 5

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next