No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R012C00 Configuration Guide - IP Multicast

This document describes the configurations of IP multicast, including IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, controllable multicast, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Clearing MLD Snooping Entries

Clearing MLD Snooping Entries


MLD snooping entries are classified into static and dynamic entries, which are cleared in different ways.


Static entries cannot be restored after being cleared and can be created when you configure static member ports.

After you clear the dynamic entries, hosts in a VLAN cannot receive certain multicast flows until the forwarding entries are generated based on MLD Report messages received from hosts.


  • Run the undo mld-snooping static-group { group-ipv6-address [ source source-ipv6-address ] vlan vlan-id | all } command in the interface view to remove an interface from a static multicast group.
  • Run the reset mld-snooping group { all | vlan vlan-id [ [ source-address source-ipv6-address ] group-address group-ipv6-address ] } command in the user view to clear dynamic group entries.
Updated: 2018-09-01

Document ID: EDOC1100037948

Views: 13136

Downloads: 5

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next