No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R012C00 Configuration Guide - IP Multicast

This document describes the configurations of IP multicast, including IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, controllable multicast, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configured IPv6 Multicast Group Policy Fails to Take Effect

Configured IPv6 Multicast Group Policy Fails to Take Effect

Fault Description

After a multicast group policy is configured on a switch, hosts still receive multicast data sent to other multicast groups out of the specified range.


  1. Run the display acl ipv6 command to check whether the configured ACL6 rules match the multicast group policy.
  2. Run the display mld-snooping configuration command to check whether the multicast group policy configured in a VLAN is correct. If not, run the mld-snooping group-policy command to configure the correct multicast group policy.
  3. Run the display current-configuration command to check whether the switch is enabled to discard unknown multicast packet. If not, run the multicast drop-unknown command to enable the switch to discard unknown multicast packets.
Updated: 2018-09-01

Document ID: EDOC1100037948

Views: 13109

Downloads: 5

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next