No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R012C00 Configuration Guide - IP Multicast

This document describes the configurations of IP multicast, including IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, controllable multicast, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Summary of Multicast VLAN Replication Configuration Tasks

Summary of Multicast VLAN Replication Configuration Tasks

Multicast VLAN replication can be configured in different methods depending on the application scenario. Table 4-1 lists multicast VLAN replication configuration tasks.

Table 4-1  Multicast VLAN replication configuration tasks
Task Description

Configuring 1-to-N Multicast Replication Based on User VLANs

When user VLAN-based 1-to-N multicast VLAN replication is configured on a switch, the upstream device only needs to send one copy of multicast data to the switch. The switch then replicates multicast data and sends the data to multiple user VLANs. This saves bandwidth between the upstream device and the switch.

Configuring N-to-N Multicast VLAN Replication Based on User VLANs

N-to-N multicast VLAN replication is a supplement to the traditional 1-to-N multicast VLAN replication mode. This mode enables you to bind a user VLAN to multiple multicast VLANs by configuring a static flow in the multicast VLANs. If user VLANs connected to the switch require multicast data from multiple ISPs, configure N-to-N multicast VLAN replication on the switch.

Configuring Interface-based Multicast VLAN Replication

By binding user VLANs to a multicast VLAN on a user-side interface, you can implement multicast service isolation on the interface while allowing multicast data replication to user VLANs. For example, when multiple ISPs provide multicast services on a network, you can configure this function to ensure that data of an ISP is forwarded only to the users who have subscribed to the services of the ISP.

Updated: 2018-09-01

Document ID: EDOC1100037948

Views: 13360

Downloads: 5

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next