No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R012C00 Configuration Guide - IP Multicast

This document describes the configurations of IP multicast, including IGMP snooping, MLD snooping, static multicast MAC address, multicast VLAN replication, controllable multicast, multicast network management.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring Interface-based Multicast VLAN Replication

Configuring Interface-based Multicast VLAN Replication

Configuration Procedure

Interface-based multicast VLAN replication implements multicast service isolation in the same user VLAN and improves control on multicast service flows.


Currently, the switch supports interface-based multicast VLAN replication only on IPv4 networks. This function must be used with Internet Group Management Protocol (IGMP) snooping. The configuration of interface-based multicast VLAN replication is similar to the configuration of multicast VLAN replication based on user VLANs, except that IGMP snooping does not need to be enabled in user VLANs. You only need to run the vlan vlan-id command to create user VLANs.

Perform the configuration in the listed sequence:

Updated: 2018-09-01

Document ID: EDOC1100037948

Views: 13331

Downloads: 5

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next