No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S600-E V200R012C00 Configuration Guide - VPN

This document describes the configurations of VPN, including IPSec, MCE.
Rate and give feedback :
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Binding Interfaces to a VPN Instance

Binding Interfaces to a VPN Instance


A VPN instance has been created and the IPv6 address family has been enabled for the VPN instance.


  • After configuring a VPN instance on a PE, bind the interface that belongs to the VPN to the VPN instance. If the interface belonging to the VPN is not bound to the VPN instance, the interface functions as a public network interface and cannot forward VPN data.
  • An interface becomes a private network interface after being bound to a VPN instance. You must configure an IP address for the interface so that the PE can exchange routing information with its connected CE.
  • After an interface is bound to a VPN instance, configuration of Layer 3 features (IPv4 and IPv6 features) including IP addresses and routing protocols is deleted from the interface.
  • When you disable an address family (IPv4 or IPv6 address family) in a VPN instance, the address family is deleted from the interface. If no address family is configured on the interface, the interface is unbound from the VPN instance.

Perform the following steps on the MCE devices.


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The view of the interface to be bound to a VPN instance is displayed.

  3. Run ip binding vpn-instance vpn-instance-name

    The interface is bound to the VPN instance.

  4. Run ipv6 enable

    IPv6 is enabled on the interface.

    private network interface

  5. Run ipv6 address { ipv6-address prefix-length | ipv6-address/prefix-length }

    An IPv6 address is configured for the interface.

    Some Layer 3 features such as route exchange between the PE and CE can be configured only after an IPv6 address is configured for the private network interface on the PE.

Updated: 2018-09-01

Document ID: EDOC1100037956

Views: 2557

Downloads: 7

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next