No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Switching to the MSTP Mode

Switching to the MSTP Mode


If an interface on an MSTP-enabled device is connected to an STP-enabled device, the interface switches to the STP-compatible mode.

If the STP-enabled device is switched to MSTP mode, or if it is powered off or disconnected from the MSTP-enabled device, the interface cannot switch to MSTP mode. In this case, use the stp mcheck command to switch the interface to MSTP mode.


  • Switch to the MSTP mode in the interface view.
    1. Run system-view

      The system view is displayed.

    2. Run interface interface-type interface-number

      The view of the Ethernet interface that participates in spanning tree calculation is displayed.

    3. Run stp mcheck

      The device is switched to the MSTP mode.

  • Switch to the MSTP mode in the system view.
    1. Run system-view

      The system view is displayed.

    2. (Optional) Run stp process process-id

      The MSTP process view is displayed.


      Skip this step if you perform configurations in the MSTP process 0.

    3. Run stp mcheck

      The device is switched to the MSTP mode.

Updated: 2019-01-18

Document ID: EDOC1100038103

Views: 116132

Downloads: 52

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next