No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
What Should Be Noted When Configuring RRPP?

What Should Be Noted When Configuring RRPP?

  • Limited by hardware specifications, the Rapid Ring Protection Protocol (RRPP) can use a maximum of 96 ACL rules on a 24-port board and 144 ACL rules on a 48-port board. When multiple RRPP rings are configured, allocate ACL rules properly.

  • RRPP and the Multi-Spanning Tree Protocol (MSTP) cannot be enabled on the same interface. Before creating an RRPP ring, disable STP on the interfaces to be added to the RRPP ring.

  • The RRPP convergence speed depends on the number of domains and rings. The convergence speed is high when the number of domains and rings is small.

Updated: 2019-01-18

Document ID: EDOC1100038103

Views: 115141

Downloads: 52

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next