No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Creating an ERPS Ring

Creating an ERPS Ring


ERPS works for ERPS rings. An ERPS ring consists of interconnected Layer 2 switching devices configured with the same control VLAN and data VLAN. Before configuring other ERPS functions, you must configure an ERPS ring.


  1. Run system-view

    The system view is displayed.

  2. Run erps ring ring-id

    An ERPS ring is created and the ERPS ring view is displayed.

  3. (Optional) Run description

    The description of the device is configured. The description can contain the ERPS ring ID, which facilitates device maintenance in an ERPS ring.

    By default, the description of an ERPS ring is the ERPS ring name, for example, Ring 1.

Updated: 2019-01-18

Document ID: EDOC1100038103

Views: 126821

Downloads: 53

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next