No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting the Maximum Transmission Rate of a Port

Setting the Maximum Transmission Rate of a Port


The maximum transmission rate of a port indicates the maximum number of BPDUs sent per second. A larger value of the maximum transmission rate of a port indicates more BPDUs sent at an interval of Hello time and therefore more system resources are occupied.

Setting the proper value of this parameter prevents excess bandwidth usage when route flapping occurs. If network flapping occurs frequently, and the switch needs to detect topology change in a timely manner and has sufficient bandwidth resources, set a large value for this parameter.


  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The view of the interface that participates in spanning tree calculation is displayed.

  3. Run stp transmit-limit packet-number

    The maximum number of BPDUs that the port can send at an interval of Hello time is set.

    By default, a port sends a maximum of 6 BPDUs per second.


    If the maximum number of BPDUs needs to be set on all ports of the switch, run the stp transmit-limit (system view) command.

Updated: 2019-01-18

Document ID: EDOC1100038103

Views: 127004

Downloads: 53

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next