No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Adding an Eth-Trunk to an E-Trunk

Adding an Eth-Trunk to an E-Trunk


After you configure an E-Trunk, add Eth-Trunks to the E-Trunk. Then the E-Trunk implements backup of LAGs between the two member devices to enhance network reliability.


  1. Run system-view

    The system view is displayed.

  2. Run interface eth-trunk trunk-id

    The Eth-Trunk interface view is displayed.

    Only Eth-Trunks in LACP mode can be added to an E-Trunk.

  3. Run e-trunk e-trunk-id [ remote-eth-trunk eth-trunk-id ]

    The Eth-Trunk is added to an E-Trunk.

    An Eth-Trunk can be added to only one E-Trunk.

    The IDs of the Eth-Trunks added to an E-Trunk can be different on two E-Trunk member devices. In this case, you must specify the remote-eth-trunk parameter to enable the E-Trunk to work normally.

Updated: 2019-01-18

Document ID: EDOC1100038103

Views: 126809

Downloads: 53

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next