No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Creating an E-Trunk and Setting the E-Trunk Priority

Creating an E-Trunk and Setting the E-Trunk Priority

Context

The E-Trunk priority determines the master or backup role of an E-Trunk member device.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run e-trunk e-trunk-id

    An E-Trunk is created and the E-Trunk view is displayed, or the view of an existing E-Trunk is directly displayed.

    The member devices in an E-Trunk must be configured with the same E-Trunk ID.

    A maximum of 16 E-Trunks can be created on a device.

  3. Run priority priority

    The E-Trunk priority is set.

    The E-Trunk priority is used for master/backup negotiation between two devices. The device with a higher priority is the master. In priority comparisons, numerically lower values have higher priority.

    If the two devices have the same priority, the device with a smaller system ID is the master.

    By default, the E-Trunk priority of a member device is 100.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038103

Views: 127005

Downloads: 53

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next