No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Extended MAC Entry Resource Mode

Configuring the Extended MAC Entry Resource Mode


You can increase the MAC address table size by changing the MAC entry resource mode.

When the switch transmits heavy traffic, MAC address entries increase accordingly. If the current MAC address table size cannot meet service requirements, service running efficiency is reduced. LPUs of the switch provide an extended register that you can use to increase the size of the MAC address table, thereby enabling the switch to learn more MAC addresses.


  1. (Optional) Run display resource-assign configuration

    The extended entry resource mode is displayed.

  2. Run system-view

    The system view is displayed.

  3. Run assign resource-mode slot slot-id mode enhanced-mac

    The extended MAC entry resource mode is configured.


    After the extended MAC entry resource mode is configured, you must restart the LPU of the switch to make the configuration take effect.

Verifying the Configuration

Run the display resource-assign configuration command to check the configuration of the resource allocation mode.

Updated: 2019-01-18

Document ID: EDOC1100038103

Views: 127243

Downloads: 53

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next