No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Creating an MSTP Process

Creating an MSTP Process


A process ID uniquely identifies an MSTP process. After the ports on an MSTP-enabled device are bound to different processes, the switch performs MSTP calculation based on processes, with only relevant ports in each process taking part in MSTP calculation. To create an MSTP process, perform the following procedure on the devices connected to access rings.


  1. Run system-view

    The system view is displayed.

  2. Run stp process process-id

    An MSTP process is created and the MSTP process view is displayed.

  3. Run stp mode mstp

    A working mode is configured for the MSTP process.

    The default mode is MSTP.

    • A default MSTP process with the ID 0 is established when a device starts. MSTP configurations in the system view and interface view belong to this process. The default working mode of this process is MSTP.

    • To add an interface to an MSTP process whose ID is not 0, run the stp process command followed by the stp binding process command.

Updated: 2019-01-18

Document ID: EDOC1100038103

Views: 126624

Downloads: 52

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next