Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document.
Note: Even the most advanced machine translation cannot match the quality of professional translators.
Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Link Aggregation Configuration
This chapter describes how to configure link aggregation. Link aggregation bundles multiple Ethernet links into a logical link to increase bandwidth, improve reliability, and load balance traffic.
- Overview of Link Aggregation
- Understanding Link Aggregation
- Application Scenarios for Link Aggregation
- Summary of Link Aggregation Configuration Tasks
- Licensing Requirements and Limitations for Link Aggregation
- Default Settings for Link Aggregation
- Configuring Link Aggregation in Manual Mode
- Configuring Link Aggregation in LACP Mode
- Configuring Preferential Forwarding of Local Traffic in a CSS
- Creating an Eth-Trunk Sub-interface
- Configuring an E-Trunk
- Maintaining Link Aggregation
- Configuration Examples for Link Aggregation
- Troubleshooting Link Aggregation
- FAQ About Link Aggregation
- References for Link Aggregation
Previous
