No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
How to Configure the MSTP Region?

How to Configure the MSTP Region?

The MSTP region is configured in the stp region-configuration view. The devices in the same MSTP region share the same MSTP region configuration. A device is deleted of the region if the MSTP region setting of the device is changed.

The following parameters can be set for an MSTP region:

  • Format selector: The default value is 0 and cannot be set through the command.

  • Region name: It is the bridge MAC address by default.

  • Revision level: The default value is 0.

  • Instance/Vlans Mapped: Mapping between instances and VLANs. By default, all VLANs are mapped to instance 0.

Updated: 2019-01-18

Document ID: EDOC1100038103

Views: 125111

Downloads: 52

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next