No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring VPLS-based Layer 2 Protocol Transparent Transmission

Configuring VPLS-based Layer 2 Protocol Transparent Transmission

When the backbone network is the L2VPN that is built based on VPLS, you can configure VPLS-based Layer 2 protocol transparent transmission so that protocol packets from different user networks can be transmitted on the backbone network.

Pre-configuration Tasks

Before configuring VPLS-based Layer 2 protocol transparent transmission, deploy VPLS-based L2VPN on PEs and the backbone network. For details, see VPLS Configuration in S12700 V200R012C00 Configuration Guide - VPN.

Updated: 2019-01-18

Document ID: EDOC1100038103

Views: 119584

Downloads: 52

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next