No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Default Settings for Link Aggregation

Default Settings for Link Aggregation

Table 3-7  Default settings for link aggregation


Default Value

Link aggregation mode

Manual mode

Upper threshold for the number of active interfaces


If the device is equipped with cards specified in the assign trunk command, you can run the assign trunk command to set the value, and run the display trunk configuration command to view the configuration.

Lower threshold for the number of active interfaces


LACP system priority


LACP interface priority


LACP preemption


LACP preemption delay


Timeout interval at which LACPDUs are received


Preferentially forwarding local traffic on an Eth-Trunk


Updated: 2019-01-18

Document ID: EDOC1100038103

Views: 113893

Downloads: 52

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Previous Next