No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
(Optional) Setting the RRPP Working Mode

(Optional) Setting the RRPP Working Mode

Context

The Rapid Ring Protection Protocol (RRPP) is a Huawei-specific protocol and was originally designed to run between Huawei devices only. To enable a Huawei device to communicate with a non-Huawei device, configure RRPP to work in GB mode.

The RRPP working mode is set on the master node in the RRPP domain.

NOTE:
  • Only the RRPP version defined by Huawei supports functions and configurations of edge nodes, assistant edge nodes, common interfaces, edge interfaces, and ring groups.
  • Each node on an RRPP ring must use the same working mode. Otherwise, the entire ring network cannot be restored after a transit node link recovers.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run rrpp working-mode { hw | gb }

    The RRPP working mode is set.

    The gb parameter indicates the GB standard, while the hw parameter indicates the Huawei-specific standard. To enable a Huawei device to communicate with a non-Huawei device, specify gb.

    By default, the RRPP version defined by Huawei is used.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038103

Views: 115346

Downloads: 52

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next