No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Open Ring Networking

Open Ring Networking

Open ring networking occurs at the access layer and is used to transparently transmit Layer 2 unicast and multicast services. When SEP runs at the access layer, redundancy protection switching can be implemented at the access layer and topology of the SEP segment can be displayed. On an open ring network, edge interfaces are located on two edge devices in the SEP segment.

Figure 17-10 shows a networking diagram of an open ring running SEP.

Figure 17-10  Open ring running SEP

In Figure 17-10, LSW1 to LSW5 are not directly connected and form an open ring to connect to a Layer 2 network.

Updated: 2019-01-18

Document ID: EDOC1100038103

Views: 126710

Downloads: 52

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next