No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring a QinQ Termination Sub-interface and Connecting It to an L3VPN

Configuring a QinQ Termination Sub-interface and Connecting It to an L3VPN

When users are connected through an L3VPN and the packets that CEs send to PEs carry double VLAN tags, configure a QinQ termination sub-interface and connect it to the L3VPN.

Pre-configuration Tasks

Before configuring a QinQ termination sub-interface and connecting it to an L3VPN, complete the following tasks:
  • Ensure that devices are connected correctly.
  • Configure VLANs to which CEs belong and basic Layer 2 forwarding so that packets sent from CEs to PEs carry double VLAN tags.
  • Ensure that the device is not a VCMP client.

Procedure

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038103

Views: 124048

Downloads: 52

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next