No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Verifying the Configuration of the Topology Change Notification Function

Verifying the Configuration of the Topology Change Notification Function

Procedure

  • Run the display sep interface verbose command to check information about the interfaces added to a SEP segment.
  • Run the display this command in the OAM management view to check the configuration of topology change notification on the upper-layer network topology.
Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038103

Views: 115339

Downloads: 52

Average rating:
This Document Applies to these Products
Related Documents
Related Version
Share
Previous Next