No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Enabling QinQ-based Layer 2 Transparent Transmission on an Interface

Enabling QinQ-based Layer 2 Transparent Transmission on an Interface

Context

Perform the following operations on PEs based on the required Layer 2 protocol transparent transmission mode.

NOTE:

The l2protocol-tunnel vlan and l2protocol-tunnel commands cannot specify the same protocol type on the same interface. Otherwise, the configurations conflict.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run interface interface-type interface-number

    The user-side interface view is displayed.

  3. Run port link-type hybrid

    The link type of the interface is set to hybrid.

  4. Run port hybrid untagged vlan { { vlan-id1 [ to vlan-id2 ] } &<1-10> | all }

    The interface is added to specified VLANs in untagged mode.

  5. Run port vlan-stacking vlan vlan-id1 [ to vlan-id2 ] stack-vlan vlan-id3

    The interface is configured to add an outer VLAN tag to Layer 2 protocol packets.

  6. Run l2protocol-tunnel { all | protocol-type | user-defined-protocol protocol-name } vlan { low-id [ to high-id ] } &<1-10>

    QinQ-based Layer 2 protocol transparent transmission is enabled on the interface.

    NOTE:
    • The outer VLAN tag (vlan-id3) specified in the port vlan-stacking command must be included in the VLAN range specified in the port hybrid untagged vlancommand.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038103

Views: 117090

Downloads: 52

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next