No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Application Scenarios for VLAN Aggregation

Application Scenarios for VLAN Aggregation

In Figure 5-6, an enterprise has multiple departments that connect to the Internet through different switches. For security purposes, the enterprise adds different departments to different VLANs. However, the number of available IP addresses is limited.

The requirements are as follows:

  • All departments require access to the Internet.
  • Department 1 and department 2 need to communicate with each other.
  • Department 3 and department 4 need to communicate with each other.
Figure 5-6  Networking of VLAN aggregation

VLAN aggregation and proxy ARP can be used to meet the preceding requirements. Deploy super-VLAN 2 and super-VLAN 3 on the switch, and add sub-VLAN 21 and sub-VLAN 22 to super-VLAN 2 and sub-VLAN 31 and sub-VLAN 32 to super-VLAN 3. After IP addresses are assigned to super-VLAN 2 and super-VLAN 3 on the switch, users in department 1 and department 2 can access the Internet using the IP address of super-VLAN 2, and users in department 3 and department 4 can access the Internet using the IP address of super-VLAN 3.

Therefore, VLAN aggregation allows all departments to access the Internet access and conserves IP addresses.

To allow communication between departments 1 and 2 and departments 3 and 4, configure proxy ARP on the switch in super-VLAN 2 and super-VLAN 3.

Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038103

Views: 116682

Downloads: 52

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next