No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


S12700 V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Displaying VLAN Translation Resource Usage

Displaying VLAN Translation Resource Usage


During VLAN Mapping configuration, VLAN translation resources may be insufficient. You can run command to view the total number of inbound/outbound VLAN translation resources, the number of used VLAN translation resources, and the number of remaining VLAN translation resources. The command output helps you locate faults.


  1. Run the display vlan-translation resource [ slot slot-number ] command in any view to check the VLAN translation resource usage.
  2. Run the display spare-bucket resource [ slot slot-number ] command in any view to check the usage of backup resources when VLAN translation resources conflict.


    Only the X series cards support this command.

Updated: 2019-01-18

Document ID: EDOC1100038103

Views: 124125

Downloads: 52

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next