No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

S12700 V200R012C00 Configuration Guide - Ethernet Switching

This document describes the configuration of Ethernet services, including configuring MAC address table, link aggregation, VLANs, VLAN aggregation, MUX VLAN, VLAN termination, Voice VLAN, VLAN mapping, QinQ, GVRP, VCMP, STP/RSTP/MSTP, VBST, SEP, RRPP, ERPS, LBDT, and Layer 2 protocol transparent transmission.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring L2VPN

Configuring L2VPN

Context

After a Dot1q termination sub-interface is configured, you need to configure the virtual private network (VPN) service on the sub-interface so that users at both ends of the L2VPN can communicate with each other.

L2VPN includes Virtual leased line (VLL), Pseudo-Wire Emulation Edge to Edge (PWE3), and Virtual Private LAN Service (VPLS).
  • VLL technology emulates leased lines on an IP network to provide inexpensive, asymmetrical digital data network (DDN) service. As a point-to-point (P2P) L2VPN technology, VLL can support almost all link layer protocols.
  • PWE3 is an implementation mode of VLL and an extension of the Martini protocol. PWE3 reduces signaling costs and defines multi-segment PWs (MS-PWs), making networking modes more flexible.
  • VPLS technology implements multipoint-to-multipoint VPN networking. Using VPLS technology, an ISP can provide Ethernet-based multipoint-to-multipoint services for users through an MPLS backbone network.

For details about L2VPN, see VLL Configuration, PWE3 Configuration, and VPLS Configuration in the S12700 V200R012C00 Configuration Guide - VPN.

NOTE:
A Dot1q termination sub-interface can be bound to a VLL that provides homogeneous or heterogeneous transport in the following modes:
  • Local Kompella connection
  • Remote Kompella connection
  • Local Martini connection
  • Remote Martini connection
A Dot1q termination sub-interface supports the following VPLS connections:
  • Martini VPLS
  • Kompella VPLS
Translation
Download
Updated: 2019-01-18

Document ID: EDOC1100038103

Views: 127698

Downloads: 53

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next