No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Device Management

S9300, S9300E, and S9300X V200R012C00

This document describes the configurations of Device Management, including device status query, hardware management, CSS, SVF, PoE, OPS, OIDS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Displaying Alarm Information

Displaying Alarm Information


When a device becomes faulty, you can run the following commands to view historical alarms and existing alarms, which can be useful for troubleshooting or learning about the device running status.


  • Run the display trapbuffer command to view the alarms recently generated on the device. Alarms are recorded into a log file. You can view the log file to check historical alarms.
  • Run the display alarm active command to view the alarms that are not cleared after the device starts.
  • Run the display alarm history command to view the historical alarms that are recorded after the device starts.
  • Run the display alarm [ slot slot-id | all ] command to view alarms about hardware management on all cards or a specified card.
Updated: 2018-09-03

Document ID: EDOC1100038289

Views: 42595

Downloads: 15

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next