No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S9300, S9300E, and S9300X V200R012C00

This document describes the configurations of Device Management, including device status query, hardware management, CSS, SVF, PoE, OPS, OIDS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring the Device MAC Address

Configuring the Device MAC Address

Context

Billions of devices exist on global networks, and each device has a MAC address. MAC addresses are managed and allocated by the IEEE. Theoretically, each device has a unique MAC address. However, MAC address conflicts may occur because of incorrect configuration. In addition, you may need to use a specified MAC address for a device to suit your network requirements. To avoid address conflicts and ensure configurations match rules, you may need to change the MAC address on a device.

NOTE:

Each device is assigned a global unique identifier from the manufacturer. Do not change the MAC address of a device unless the change is absolutely necessary. If you change a MAC address, the modification takes effect only after the device restarts.

When changing the MAC address, pay attention to the following points:
  • The MAC address cannot be all 0s or all 1s.
  • The MAC address cannot be a multicast MAC address.
  • If a device supports 16 MAC addresses, the last hexadecimal digit of the MAC address must be 0. If a device supports 256 MAC addresses, the last two hexadecimal digits of the MAC address must be 0.

Procedure

  1. (Optional) Run display system-mac

    The current and default MAC addresses of the device are displayed.

  2. Run set system-mac current hex-string [ chassis chassis-id ] ( The chassis chassis-id parameter is valid only in a CSS. )

    The current MAC address of the device is configured.

    After configuring the device MAC address, restart the device for the configuration to take effect.

Translation
Download
Updated: 2018-09-03

Document ID: EDOC1100038289

Views: 42988

Downloads: 15

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next