No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Device Management

S9300, S9300E, and S9300X V200R012C00

This document describes the configurations of Device Management, including device status query, hardware management, CSS, SVF, PoE, OPS, OIDS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Software and Hardware Support for S9300E CSS Card Clustering

Software and Hardware Support for S9300E CSS Card Clustering

Device Model

  • S9306E

  • S9312E

CSS Card and Installation Slot

CSS card: LE2D2VS08000 (Eight ports on a CSS card are divided into two groups, each of which must have at least one cable connected.)

Installation slot: subcard slot of LE2D2SRUC000

CSS card and MPU models are abbreviated to VS08 and SRUC respectively.

Software Version

V200R008C00 and later versions

Hot Swap of CSS Cards

Not supported

Number of CSS Cards Supported by Each Chassis


Number of CSS Ports on Each CSS Card and Bandwidth of a Single CSS Port

Eight 10G ports

Pluggable Modules for Ports on CSS Cards

  • 1 m, 3 m, 5 m (passive), and 10 m (active) SFP+ cables

  • SFP+ optical module and fiber

  • 3 m and 10 m SFP+ AOC cables

Hardware Configuration

  • Two S9306Es, one S9306E and one S9312E, or two S9312Es can set up a CSS.
  • Switches to set up a CSS must have both active and standby MPUs installed, and the two MPUs must have stack cards installed.

License Required


Updated: 2018-09-03

Document ID: EDOC1100038289

Views: 42352

Downloads: 15

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next