No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S9300, S9300E, and S9300X V200R012C00

This document describes the configurations of Device Management, including device status query, hardware management, CSS, SVF, PoE, OPS, OIDS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Splitting a CSS

Splitting a CSS

Context

If the current CSS system no longer transmits services, split it into standalone switches.

The procedure for splitting a CSS is as follows:

  1. Back up the CSS configuration file.

  2. Delete the CSS MAC address if configured.

  3. Disable the CSS function.

  4. Restore CSS member ports to service ports. (This step is required only in the service port connection mode.)

  5. Power off the switches and remove the cluster cables.

Procedure

  1. Back up the configuration file.

    1. Run the save command to save the configuration.
    2. Run the copy source-filename destination-filename all command to back up the configuration file to the standby switch.
    NOTE:

    Back up the current configuration file to the storage medium of the standby switch before you split the CSS. You can use the configuration file to set up a CSS next time.

  2. Delete the CSS MAC address.

    1. Run the system-view command to enter the system view.
    2. Run the undo set css system-mac command to delete the CSS MAC address.

  3. Disable the CSS function.

    Run the undo css enable all command to disable the CSS function on the two member switches. The switches restore to standalone switches after they restart.

  4. Restore CSS member ports to service ports. (This step is required only in the service port connection mode.)

    Run the undo interface css-port port-id command to delete logical CSS ports on the member switches and restore CSS member ports to service ports.

    NOTE:
    • To restore a CSS member port to a service port on a standalone switch, run the undo interface css-port command.
    • To restore a CSS member port to a service port in a CSS, run the shutdown interface command in the logical CSS port view to shut down the CSS member port and then run the undo port interface enable command.

  5. Power off the switches and remove the cluster cables.

    You can also remove the cluster cables when the switches are running.

Translation
Download
Updated: 2018-09-03

Document ID: EDOC1100038289

Views: 43032

Downloads: 15

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next