No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Device Management

S9300, S9300E, and S9300X V200R012C00

This document describes the configurations of Device Management, including device status query, hardware management, CSS, SVF, PoE, OPS, OIDS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Setting Up an SVF System (The Parent Is Directly Connected to ASs)

Setting Up an SVF System (The Parent Is Directly Connected to ASs)


As shown in Figure 4-7, ASs in an SVF system are classified into level-1 and level-2 ASs. You can connect a level-1 AS to the parent and then a level-2 AS to the level-1 AS.

By default, you do not need to configure the ports that connect a level-1 AS to the parent and connect a level-2 AS to the level-1 AS because ASs are plug-and-play. You only need to configure fabric ports that connect the parent to a level-1 AS and connect a level-1 AS to a level-2 AS.

Figure 4-7  Parent is directly connected to ASs

Updated: 2018-09-03

Document ID: EDOC1100038289

Views: 38495

Downloads: 15

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next