No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search

Reminder

To have a better experience, please upgrade your IE browser.

upgrade

Configuration Guide - Device Management

S9300, S9300E, and S9300X V200R012C00

This document describes the configurations of Device Management, including device status query, hardware management, CSS, SVF, PoE, OPS, OIDS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Replacing an AS

Replacing an AS

Context

In an SVF system, each AS is identified by its MAC address by default. When a new device is used to replace an AS, the SVF system considers the new device as a new AS because their MAC addresses are different. As a result, the new AS does not inherit services on the previous AS.

You can enable AS automatic replacement to solve this problem. When an AS is replaced by a new device connected to the same fabric port, the SVF system replaces the AS MAC address with the MAC address of the new device in the configuration. Consequently, the new device can inherit services on the AS.

NOTE:
  • An AS can only be replaced by a device of the same model. If the new device is a different model, the SVF system considers it as a new AS, which then cannot inherit services on the previous AS.

  • Only a standalone AS can be replaced, and a stacked AS cannot be replaced.

  • AS automatic replacement is not supported when an AS connects to the parent through a network.

  • To ensure that a replacement AS can be successfully authenticated, run the auth-mode none command to set the AS authentication mode to none, or run the whitelist mac-address command to add the management MAC address of the replacement AS to the whitelist. If the replacement AS has no management MAC address configured, its system MAC address is used as the management MAC address.

Procedure

  1. Run system-view

    The system view is displayed.

  2. Run uni-mng

    The uni-mng view is displayed.

  3. Run as auto-replace enable

    AS automatic replacement is enabled.

  4. Replace the existing AS with a new AS. The two ASs connect to the same fabric port.
Translation
Download
Updated: 2018-09-03

Document ID: EDOC1100038289

Views: 43000

Downloads: 15

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Share
Previous Next