No relevant resource is found in the selected language.

This site uses cookies. By continuing to browse the site you are agreeing to our use of cookies. Read our privacy policy>Search


To have a better experience, please upgrade your IE browser.


Configuration Guide - Device Management

S9300, S9300E, and S9300X V200R012C00

This document describes the configurations of Device Management, including device status query, hardware management, CSS, SVF, PoE, OPS, OIDS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
Rate and give feedback:
Huawei uses machine translation combined with human proofreading to translate this document to different languages in order to help you better understand the content of this document. Note: Even the most advanced machine translation cannot match the quality of professional translators. Huawei shall not bear any responsibility for translation accuracy and it is recommended that you refer to the English document (a link for which has been provided).
Configuring PoE

Configuring PoE

Pre-configuration Tasks

Before configuring PoE, complete the following tasks:

  • Ensure that the LE0DG48VEA00 has been installed because only the LE0DG48VEA00 board supports PoE currently.
  • Install the PoE power module and power on it.
  • Connect the interfaces on the PSE to PDs to ensure that the status of the link layer protocol of the interface is Up.

Generally, the device can detect whether a PD connected to it needs power supply and provides PoE function. If you need to modify the PoE configuration or manually power on the PD, see the following configuration.

Updated: 2018-09-03

Document ID: EDOC1100038289

Views: 38376

Downloads: 15

Average rating:
This Document Applies to these Products
Related Version
Related Documents
Previous Next